0151 649 1500 1890 946244
www.einhell.co.uk
32
Electric Impact Shredder – GLEKS 2440Set up
1. Assembling the chassis (Fig. 6a/6b)
– Place the motor housing
3
upside down on the floor.
– Insert the tubular chassis
5
into the provided openings as far as the tubes will go.
– Fit the washers
17
under the heads of the screws
16
and then use the screws with the
washers to secure the chassis, as shown in Fig. 6b using a PH2 star-headed screwdriver
(not included).
Fig. 6b
5
17
16
Fig. 6a
2. Assembling the axle and wheels (Figs. 7a-7h)
– Remove the sleeves
18
&
19
, nuts
21
and washers
20
from both ends of the axle
5
.
– Mount the axle into the chassis
5
(Fig. 7a)
Fig. 7b
18
5
7
Fig. 7a
7
• Refit thick short sleeves
18
& thin long sleeves
19
(Figs. 7b-7d)
66926_3430345_11026_ug_inner.indd 32 22/03/2016 3:22 pm
To Next Page
Loading...
