10
AFTER SALES SUPPORT
1300 886 649
info@tempo.org
AUS
MODEL: STR-TLW70 PRODUCT CODE: 700586 04/2020
Getting Started: Installation
Unpacking
• This product has been packaged to protect it against transportation damage. Keep
the original packaging carton in a safe place. It will help prevent any damage if the
product needs to be transported in the future. In the event that it is to be disposed
of, please recycle it and all other packaging materials where possible.
• Plastic wrapping can be a suffocation hazard for babies and young children, so
ensure all packaging materials are out of their reach and disposed of safely.
• Unwind the power cord to its full length and inspect it for damage. Do not use
the appliance if the appliance or its cord has been damaged or is not working
properly. In case of damage, contact our after sales support centre for advice on
examination, repair or return of the damaged product.
• Read this manual to familiarise yourself with all the parts and operating principles
of the washing machine. Pay particular attention to the safety instructions on the
previous pages.
Installing the base cover
Levelling the washer
• Install the washer on a stable and level
surface, in a dry location, out of sunlight.
• If levelling is necessary, adjust the
adjustable leg (at the front right side of
the machine), as illustrated, right.
The maximum permissible inclination
of the supporting surface is 2 degrees.
CAUTION: Installing the washer on a
carpeted floor may cause vibration issues.
If you must install it on carpet, make sure
not to block any ventilation openings on the
bottom of the washer.
• Make sure the power cord is unplugged from the
mains supply.
• Place some padding (such as a soft mat, blanket or
thick towel) on the floor and gently lay the washing
machine on the padding, back side down. Take care
not to dent the housing.
• Insert the base cover into the hooks of the leg,
pushing it straight until it reaches into the back hooks.
• Fasten the base cover with the supplied screw.
• Carefully set the washer upright.
Base
cover
Back
Leg
Screw
Front
Base of the washer
(3) Tighten
(1) Loosen
(2) Down (4) Up
Adjustable leg
To Next Page
Loading...