12
AFTER SALES SUPPORT
1300 886 649
info@tempo.org
AUS
MODEL: STR-TLW70 PRODUCT CODE: 700586 04/2020
Getting Started: Installation (Cont.)
CAUTION: When tightening the clamping nut, take care not to damage the water
inlet valve joint. Apply force evenly and do not twist the water inlet valve.
Drain pump with
lint filter
Drain hose
connection
• The drain hose and drain pump filter are located at the back of the machine, as
illustrated below, left.
• Pinching the two bands of the clamp on the drain hose, connect it to the drain hose
connection at the back of the washer, as illustrated below, centre.
• Insert the hose clips for the water drainage hose (marked with red arrows in the
illustration on the right) into the mounting holes at the back of the washer. Turn the
clips so you can lead the hose through the clips up the back of the machine.
Installing the drain hose
CAUTION: Use only the new (supplied) hoses with your new appliance. Do not
use a hose from an existing machine, or one that has been used previously.
CAUTION: In the event that the hoses are too short for your set-up, please seek
advice from your local washing machine store to purchase a longer hose.
To Next Page
Loading...