ALDI STIRLING STR-TLW70 - Instructions; Before You Start Washing; Normal Usage Guide

16
AFTER SALES SUPPORT
1300 886 649
info@tempo.org
AUS
MODEL: STR-TLW70 PRODUCT CODE: 700586 04/2020
Instructions
Before you start washing
A Make sure the washer is stable
and level. If necessary, adjust the
adjustable leg (front right) to stabilise
the washer (see page 10).
B Make sure the water inlet hoses
are properly installed (see page 11).
C Plug the machine into a nearby
power outlet.
D Open the water taps.
E Make sure the drain hose is properly
installed. Hang the upper end of the
hose over the laundry sink or into a
drain spout (see page 13).
1. Before washing, remove any coins, keys and other hard items
from pockets. Close any zippers to prevent damaging your
clothes and the wash tub. Brush dirt and sand off clothes and
turn pockets inside out.
2. Sort your washing into appropriate loads: whites,
coloureds, cottons, delicates, heavily soiled, etc.
Place delicate items into a wash bag for protection.
On the back
Install
the drain
hose at a
height of
70-100cm
to prevent
water drain-
age and
overflowing
problems.
A
B
D
C
E
3. Put your washing in the machine, loading items uniformly
in the tub.
4. Add washing detergent (see opposite for details).
5. Press the Power On/Off button.
6. Refer to the program selection guide (page 17) and select a suitable wash program.*
7. Close the lid and press the Start/Pause button. (If the washer lid is not closed
properly, the washer will sound an alarm and stop working before spinning.)
8. At the end of the wash, remove your washing, unplug the power plug from the wall
outlet and close the water taps. Leave the lid open until the interior has dried.
* Sensor: The machine will automatically choose the appropriate water power and
level, and wash, spin and rinse times for the NORMAL and HEAVY DUTY programs.
Other parameters can be set individually (see page 18).
F Before using the washing machine for
the first time, run a complete cycle
without laundry items and detergent.
Select the NORMAL program and run the
machine until the end of the program.
Normal usage