ALDI STIRLING STR-TLW70 - Connecting Water Inlet Hoses

11
AFTER SALES SUPPORT
1300 886 649
info@tempo.org
AUS
MODEL: STR-TLW70 PRODUCT CODE: 700586 04/2020
Getting Started: Installation (Cont.)
Connecting the water inlet hoses
Install the water inlet hoses to your hot and cold water taps, as described below.
• Check and ensure that the sealing washers are firmly in place.
• Attach the straight end of the hose to your water taps. Make sure to attach the
hot water supply hose (with red markings) to the hot water tap and the cold water
supply hose (with blue markings) to the cold water tap.
• Tighten the coupling nuts securely by hand, as illustrated below (the sealing washer
is a part of and located inside the tap end).
• Attach the curved end of the hose to the corresponding inlet valve of the washer.
• Tighten the coupling nuts securely by hand, as illustrated below.
• Tighten the nut by turning it clockwise while holding the hose. (To detach the water
supply hose, turn the nut anticlockwise after turning the tap off.)
• Turn on the taps and check for leaks. Tighten the coupling nuts firmly if there is any
leakage. If your water pressure is strong, close the water tap completely, then open
it slightly.
IMPORTANT!
• Both the hot water and cold water hoses must be connected to your taps.
• Make sure your hot water from the tap is no hotter than 60°C.
Tap
Sealing
washer
Tap end
Inlet hose
Twist
Water inlet valve