4V Li-Ion Screwdriver
AFTER SALES SUPPORT
(toll free) MODEL No.: CSD40QU • 10/2019 10997
e-mail: info.aldi@positecgroup.com
AUS
15
1300 889 028
AUS
NOTE: For any issuses related directly to your purchased charger, contact
the Customer Service of the manufacturer as listed on the charger
packaging, manual or on the label on the charger.
This Screwdriver uses Lithium Ion Battery Cell. Care MUST be taken to
ensure both the safety and life of the pack is maintained. Ensure you
have read all of the safety notes in the previous pages before using the
Screwdriver.
Treat the
Screwdriver
with care and within the guidelines of this manual.
If the Screwdriver does become immersed in water or any fluids, or is
subject to a severe drop or it does not operate within the guidelines
of this manual or the supplied manual, immediately STOP using the
Screwdriver and have it checked.
Use only supplied 4V battery charger.
Assembly
Selecting a bit (See Fig. A1-A3)
1) Pull the top slide cover (4) backwards completely.
2) Manually rotate the bit cartridge (3) anti-clockwise until the desired
bit appeared in the top window (14).
3) Push the top slide cover (4) forwards completely. The magnetic chuck
will hold the bit firmly in place
NOTE: The screwdriver will not operate if the top slide cover is not fully
pushed forwards.
A1 A3A2
Important information – Product care
14
To Next Page
Loading...
Need help?
General
