GB
IRE
00800 34 99 67 53
− Only parts that comply with the original device data and the
manufacturer's specifications may be used for repairs. Elec-
trical and mechanical parts, which are essential for providing
protection against sources of danger, are located in this cord-
less drill.
Troubleshooting
Some problems may be caused by minor faults that you can fix yourself. To do so, fol-
low the instructions in the following table.
If it is still not possible to resolve the problem with the cordless drill, contact customer
service. Do not in any case attempt to repair the cordless drill yourself.
Problem Possible cause Solution
1. The cordless
drill cannot be
started.
The rechargeable
battery does not have
enough power.
Charge the rechargeable battery
(see chapter “Charging the re-
chargeable battery”).
The rechargeable
battery has not been
inserted properly.
Push the rechargeable battery into
the cordless drill until it locks into
place.
Right-handed/
left-handed rotation
selector is in the mid-
dle position.
Push right-handed or left-handed
rotation selector all the way in.
2. The rechargea-
ble battery does
not charge.
The rechargeable
battery has not been
inserted properly.
Push the rechargeable battery into
the charger
10
so that the con-
tacts of the rechargeable battery
extend into the charger. The re-
chargeable battery must lock into
the charger.
The mains plug has not
been inserted properly.
Check to make sure that the mains
plug is properly seated.
The socket has no
power.
Check the socket by connecting
another device.
The mains adapter,
the rechargeable bat-
tery or the charger is
defective.
Contact the customer service.
To Next Page
Loading...
Need help?
General
