Chapter 2: Playing the A6
42 ANDROMEDA A6 REFERENCE MANUAL
CNTL Page Parameters
The abbreviation for “Controllers”, this page permits you to enable/disable local and
MIDI controllers for the selected Mix Channel.
The parameters on this page determine whether or not the displayed controllers
affect the currently selected Mix Channel. Use the parameter’s corresponding soft
knob to turn the function on or off.
PAGE PARAMETER
OPTIONS
or RANGE
DESCRIPTION
PCHWHL ON, OFF
Enables, disables the A6’s Pitch Wheel.
CNTL
Page 1
MODWHL
ON, OFF
Enables, disables the A6’s Modulation Wheel.
AFTCH ON, OFF
Enables, disables keyboard Aftertouch. MIDI In
aftertouch is turned off or on in Page 2, below.
SUSPDL ON, OFF
Enables, disables the rear panel SUSTAIN jack and
MIDI In sustain pedal control.
EXTSW ON, OFF
Enables, disables the rear panel SWITCH jack.
EXTPDL ON, OFF
Enables, disables the rear panel CC PEDAL jack.
RIBBON ON, OFF
Enables, disables the A6’s Ribbon Controller.
- KBD - ON, OFF
Enables, disables the A6’s keyboard.
The CNTL parameter group contains 16 parameters, displayed eight at a time. Press soft button
7 to toggle between the two display sub-pages.
MID IN ON, OFF
Enables, disables MIDI In control of the current
Mix Channel.
CNTL
Page 2
MIDOUT ON, OFF
Enables, disables MIDI Out control from the
current Mix Channel.
MIDCC ON, OFF
Enables, disables MIDI continuous controller
commands such as sliders and knobs on another
MIDI device.
MIDVOL ON, OFF
Enables, disables MIDI volume control.
MIDPGM ON, OFF
Enables, disables MIDI program change
commands.
MIDAFT ON, OFF
Enables, disables MIDI Aftertouch.
SOLO function
This is not a “page”, actually; you can press Soft Button 8 to solo a Mix Channel
when you’re on any of the pages of Mix mode. This “solos” the currently selected
Mix Channel (indicated by the green blinking LED over the SELECT button) so you
can concentrate on one layer of a Mix without hearing the others.
To Next Page
Loading...
Need help?
General
