Safety Instructions
Carefully read the applicable items of the operating instructions and these safety
suggestions before using this product. Use extra care to follow the warnings
written on the product itself and in the operating instructions. Keep the operating
instructions and safety suggestions for reference in the future.
1. Power Source. The product should only be connected to a power supply which is described
either in the o
perating instructions or in markings on the produ
ct.
2. Powe
r Cord Protection
. AC power supply cords should be placed such that no one is likely to
step on the
cords and such that nothing will be placed on or again
st them.
3.
Periods of Non-use
. If the product is not used for any significant period of time, the product's
AC power
supply cord should be unplugged from the
AC outlet.
4.
Foreign Objects and Liquids
. Take care not to allow liquids to spill or objects to fall into any
openi
ngs of the product.
5.
Water or Moisture
. The product should not be used near any water or in moisture.
6. Heat
. Do not place the product near heat sources such as stoves, heat registers, radiators or
other he
at producing equi
pment.
7. Ventilation
. When installing the product, make sure that the product has adequate
ventilation. Improperly ventilating the product may cause overheating, which may damage the
product.
8. Mounting
. The product should only be used with a rack which the manufacturer
recomme
nds. The combination of the product and rack should be moved carefu
lly. Quick
movement
s, excessive force or uneven surfaces may overturn the combination whi
ch may
damag
e the product and rack combinatio
n.
9. Clea
ning
. The product should only be cleaned as the manufacturer recommends.
10. Service
. The user should only attempt the limited service or upkeep specifically described in
the operating
instructions for the user. For any other service required, the product should be
taken to an authorized service center as described in the operating instruction
s.
11.
Damage to the Product
. Qualified service personnel should service the unit in certain
situation
s including without limitation wh
en:
a.
Liquid has spilled or objects have fallen into the produc
t,
b.
The product is exposed to water or excessive moi
sture,
c.
The AC power supply plug or cord is da
maged,
d.
The product shows an inappropriate change in performance or does not ope
rate
normally, or
e.
The enclosure of the product has been damaged.
To Next Page
Loading...
Need help?
General
