Alesis MULTIMIX8 USB2.0 - Mac CoreAudio Integration

5
USB2.0 Recording
42
Using the MultiMix USB2.0 with
CoreAudio on the Macintosh
To configure the MultiMix for use with CoreAudio:
1. Open the Mac’s “Audio MIDI Setup” utility.
2. Choose the “Alesis USB Audio Device” as both input and
output device.
3. To verify that the MultiMix USB 2.0 is connected to your Mac,
select the “Alesis USB Audio Device” under “Properties
For:” and then press “Configure Device.”
Mac OS X 10.4 or higher is
required by the MultiMix
drivers.