Alfa Laval ThinkTop v.3.0 - Safety Precautions

2 Safety
Unsafe practices and other important information are emphasized in this manual.
Warnings are emphasized by means of special signs. All warnings in the manual are summarized on this page.
Pay special attention to the instructions below so that severe personal injury or damage to the top unit are avoided.
2.3 Safety precautions
Installation
Always
read the technical data thoroughly.
Never
install the ThinkTop
®
before valve or relay is in a safe position.
If welding close to the ThinkTop
®
:A
Always
earth close to the welding area.
Disconnect the ThinkTop
®
.
Always
have the ThinkTop
®
electrically connected by authorised personnel.
Maintenance
Always
read the technical data thoroughly.
Always
fit the seals between valve and ThinkTop
®
correctly.
Never
service the ThinkTop
®
before valve or relay is in a safe position.
Never
service the ThinkTop
®
with a valve/actuator under pressure.
Never
clean the ThinkTop
®
with high-pressure cleaning equipment.
Never
use cleaning agents when cleaning the ThinkTop
®
. Check with cleaning agent supplier.
6