1 Preface
This manual provides information needed to install, operate and carry out
maintenance of your gasketed plate-and-frame heat exchanger.
The following models are covered in this manual:
• M15
• TL10
• TL15
• T20
• TS20
• MX25
• T25
• MA30
• WideGap 100
• WideGap 200
1.1
Conditions and Requirements
Prior knowledge
The heat exchanger shall be operated by persons who have studied the
instructions in this manual and have knowledge of the process. This includes
knowledge of precautions regarding media type, pressures, temperatures in
the heat exchanger as well as specific precautions required by the process.
Maintenance and installation of the heat exchanger shall be done by persons
who have knowledge and authorization according to local regulations. This
may include actions such as piping, welding and other kind of maintenance.
For maintenance actions not described in this manual, contact your Alfa Laval
representative for advice.
PHE drawings
PHE (plate heat exchanger) drawings mentioned in the manual are the
drawings included in the delivery of the heat exchanger.
Warranty conditions
The warranty conditions are usually included in the signed sales contract prior
to the order of the delivered heat exchanger. Alternatively, the warranty
conditions are included in the sales offer documentation or with a reference to
the document specifying the valid conditions. If faults occur during the
specified warranty period, always consult your local Alfa Laval representative
for advice.
Report the date when the heat exchanger was put into operation to the local
Alfa Laval representative.
200000418-2-EN-GB 7
EN
To Next Page
Loading...
Need help?
General
