Need help?Do you have a question about the Alfa Laval T5 and is the answer not in the manual?
General| Type | Plate Heat Exchanger |
|---|---|
| Gasket Material | NBR, EPDM |
| Frame Material | Carbon Steel |
| Max. Working Pressure | Up to 25 bar |
| Temperature Range | -10°C to 180°C |
| Capacity | Varies depending on configuration |
| Material | Stainless Steel, Carbon Steel |
| Power Supply | Not applicable |
| Operating Pressure | Up to 25 bar |
| Operating Temperature | -10°C to 180°C |
| Plate Material | Stainless Steel |
| Max. Flow Rate | Varies by model and configuration |
General safety guidelines for using and maintaining the heat exchanger as instructed.
Information found on the unit's name plate, including technical specifications and warnings.
Checks and considerations before installing the heat exchanger, including piping and safety.
Procedures and precautions for safely starting up the heat exchanger.
Step-by-step procedure for safely shutting down the heat exchanger.
Procedures for cleaning the heat exchanger without opening it, including CIP.
Steps for safely opening the heat exchanger for manual cleaning or inspection.
Steps to properly reassemble and close the heat exchanger after maintenance.
Procedure for pressure testing the heat exchanger to confirm sealing after maintenance.
Instructions for replacing gaskets on plates, including Clip-on and ClipGrip types.
To Next Page
