Alfa Network 2622 - Using the Seam Guides on the Needle Plate; Turning Square Corners; Variable Needle Position

15
1
2
3
4
5
2
1
2
4
3
5
0
Using the Seam Guides on the Needle Plate
The seam guides on the needle plate help you to measure
seam width.
* The numbers indicate the distance between the center
needle position and the guide line.
Numbers on the needle plate
Distance in centimeters
15 2010
1.3 1.6 1.9
6/8"5/8"4/8"3/8"
2.01.51.0 1.0
Guide lines
Cornering guide
Needle plate
Needle plate hole
Seam width from the center needle position
Turning Square Corners
To turn a square corner 1.6 cm (5/8") from the fabric edge.
When the fabric edge facing you lines up with the cornering
guide as illustrated, stop stitching and lower the needle by
turning the handwheel towards you.
Raise the presser foot and turn the fabric to line the edge with
the 1.6 cm (5/8") seam guide.
Lower the presser foot and begin stitching in the new direction.
Cornering guide
1
2
3
4
5
2
Variable Needle Position
When the straight stitch (pattern A) is selected, you can move
the needle between center and left needle position by turning
the stitch width dial.