3
-Net…..............................................................................................................................................................110 kg
-Gross.............................................................................................................................................................128 kg
1.0 THE PURPOSE OF THIS MANUAL
The purpose of this Manual is to enable the user to take all necessary measures and prepare all necessary equipment
and materials in order to ensure the safe and proper exploitation i.e. use of the stove.
1.1 UPDATING
This Manual presents the state-of-the-art at the moment the stove is placed on the market. Therefore, ALFA PLAM
does not take into account the stoves already on the market with appropriate technical documents, and considers them
faulty or inadequate after any modifications, adaptations or application of new technologies to newly launched
machines.
The contents of this Manual must be read and study very carefully. You should strictly adhere to all the instructions
given in this Manual. All the information included in this booklet is necessary for the installation, use and maintenance
of your stove.
Therefore, this Manual must be carefully kept because of its instructions that may be necessary if any problem or
ambiguity arises.
If the stove is handed over or resold to another person, the new owner must also be given this Manual.
If you lose this booklet, you can ask the manufacturer for a new one.
2.0 THE RESPONSIBILITY OF THE MANUFACTURER
Upon publishing this Manual, ALFA PLAM will not accept any civil or legal responsibility, either direct on indirect,
due to:
− Accidents occurred due to the non-observance of the standards and specifications stated in this
Manual,
− Accidents occurred due to the improper operation or use of the stove by the user,
− Accidents occurred due to any modifications and repairs not approved by ALFA PLAM,
− Poor maintenance,
− Unpredictable events,
− Accidents occurred due to the use of spare parts that are not original spare parts or that are not
intended for these models of the stove.
The installer of the stove shall take the full responsibility for the installation.
2.1 THE BASIC CHARACTERISTICS OF THE USER
The user must have the following basic characteristics:
− To be a responsible adult,
− To have certain technical knowledge needed for the routine maintenance of the electric and mechanical
components of the stove.
CHILDREN MUST NOT APPROACH THE STOVE OR PLAY WITH IT WHILE IT IS IN OPERATION.
2.2 THE TRANSPORTATION AND USE OF THE STOVE – HANDLING
During the use of the stove care should be taken that the stove is not leaned forward because the centre of gravity of
the stove is oriented forward.
While moving the stove, which must be carried out absolutely safely, ensure that the forklift truck has a carrying
capacity that is higher than the weight of the stove it should lift. Avoid twitches and abrupt movements.
ALL THE PACKAGING MATERIAL SHOULD BE REMOVED AWAY FROM THE REACH OF CHILDREN AS THE
MATERIALS CONTAINED IN THE PACKAGING MAY CAUSE SUFFOCATION. THESE INCLUDE PLASTIC BAGS,
FILMS, STYROFOAM, ETC.
2.3 THE RESPONSIBILITY OF THE INSTALLER
The responsibility of the installer is to perform all the checkups of the flue piping, air intake/supply, as well as all the
solutions required for the installation (incorporation) of your stove.
The responsibility of the installer is to ensure that the stove is in compliance with local regulations applicable in the
place where the stove is installed (incorporated).
The use of the stove must be in accordance with the instructions given in this Manual for use and maintenance, as
well as with all the safety standards prescribed by local legal regulations applicable in the place where the stove is
installed (incorporated).
The installer must verify (confirm):
− The type of the stove that is being installed,
− Whether the room in which the stove is being installed is appropriate, which is expressed as the minimum size of the
room required for the installation as prescribed by the stove manufacturer,
− Instructions of the heat generator manufacturer, related to the requirements of the smoke discharge system (smoke
discharge ducts and pipes),
− The internal cross section of the chimney, material the chimney is made of, cross-sectional uniformity, whether there
are any obstacles and barriers in the chimney,
− The height and vertical extension of the chimney,
To Next Page
Loading...