Alicat M Series - Figure 4. Optional Industrial Connector; Figure 5. Proper Set up for Remote Tare on Meters

9
An industrial connector is standard on all CSA/ATEX approved devices (see pages 46 & 47). It is also
available as an option on all other Alicat instruments.
1
6
5
4
3
2
Pin Function Cable Color
1
Power In (
+ )
Red
2 RS-232TX / RS-485 + Blue
3 RS-232RX / RS-485 - White
4 Remote Tare (Ground to Tare) Green
5 Ground (common for power,
communications and signals)
Black
6 Signal Out (Voltage or Current as ordered) Brown
Figure 4. Optional Industrial Connector
Note: The above pin-out is applicable to all the fl ow meters and controllers ordered with the industrial
connector. The availability of different output signals depends on the fl ow meter options ordered.
Figure 5. Proper set up for remote tare on meters (Momentarily ground Pin 4 to Tare)
DB15 Pin-out Diagrams:
Pin-out diagrams for devices ordered with a DB15 connector can be
found on pages 44 and 45 .
PROFIBUS Pin-out Diagrams:
Pin-out diagrams for PROFIBUS confi gured devices can be found on page 35 and 43.