Setting up the monitor | 37
13. Slide the tabs on the I/O cover into the slots on the display back cover until
it snaps into place.
NOTE: Ensure that all cables pass through the I/O cover and cable-
management slot on the stand riser.
Connecting the computer
WARNING: Before you begin any of the procedures in this section,
follow the Safety instructions.
NOTE: Do not connect all the cables to the
computer at the same time.
NOTE: The images are for the purpose of illustration only. The
appearance of the computer may vary.
1. Connect
the other end of the DisplayPort-DisplayPort/USB-C-
DisplayPort/HDMI cable to your computer.
2. Connect
the other end of the USB 3.2 Gen 1 upstream cable to an
appropriate USB 3.2 Gen 1 port on your computer.
3. C
onnect the USB peripherals to the SuperSpeed USB 5 Gbps (USB 3.2
Gen 1) downstream ports at the bottom of the monitor.
4. Pl
ug the power cables of your computer and monitor into a wall outlet.
5. Tur
n on the monitor and the computer.
If your monitor displays an image, installation is complete. If it does not
di
splay an image, see Common problems.
To Next Page
Loading...
