24 | Setting up the monitor
Setting up the monitor
Attaching the stand
NOTE: The stand is not factory-installed.
NOTE: The following instructions are only applicable for the stand that
was shipped with your monitor. If you are attaching a stand that you
purchased from any other source, follow the set up instructions that were
included with the stand.
CAUTION: The following steps are important to protect
your curved
screen. Do follow the instructions below to finish up the installation.
1. Remove the stand riser and stand ba
se from the packaging cushion.
2. Align and place the stand riser on the stand base.
3. O
pen the screw handle at the bottom of the stand base and turn it
clockwise to secure the stand assembly.
4. C
lose the screw handle.
To Next Page
Loading...
