4. Connect the keyboard-backlight cable to the keyboard-contoller board and close the latch to secure the cable.
5. Connect the keyboard cable to the keyboard-controller board and close the latch to secure the cable.
6. Connect the keyboard-controller board cable to the system board and close the latch to secure the cable.
Next steps
1. Install the
battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
System board
Removing the system board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the memory.
4. Remove the 2230 solid-state drive or 2280 solid-state drive in slot one, whichever applicable.
5. Remove the
2230 solid state drive or 2280 solid-state drive in slot two, whichever applicable.
6. Remove the wireless card.
7. Remove the rear-I/O cover.
8. Remove the battery.
About this task
NOTE: When removing this component, please refer to the techsheet bundled with the service kit. This is only applicable for
computers with the following Graphics Processing Unit (GPU) configurations that have Element 31 grease is applied to the CPU.
● NVIDIA GeForce RTX 3070 Ti
● NVIDIA GeForce RTX 3080 Ti
The following image indicates the connectors on your system board.
50
To Next Page
Loading...
