4. Align the screw hole on the wireless-card bracket with the screw hole on the wireless card and palm-rest and keyboard assembly.
5. Replace the screw (M1.6x1.8) that secures the wireless-card bracket to the wireless card and the palm-rest and keyboard
assembly.
6. Align the screw hole on the wireless card thermal shield with the screw hole on the palm-rest and keyboard assembly.
7. Replace the screw (M2x3) that secures the wireless card thermal shield to the wireless card and palm-rest and keyboard assembly.
NOTE: The wireless card thermal shield is applicable for computers shipped with certain configurations only.
Next steps
1. Install the base cover.
2. Follow the procedure in
After working inside your computer.
Rear-I/O cover
Removing the rear I/O-cover
Prerequisites
1. Follow the procedure in
Before working inside your computer.
2. Remove the base cover.
About this task
The following image(s) indicate the location of the rear I/O-cover and provides a visual representation of the removal procedure.
21
To Next Page
Loading...
