CAUTION: To avoid damaging your computer, ensure that the Tron-light cable is not pinched when sliding the rear
I/O-cover into palm-rest and keyboard assembly.
Steps
1. With the correct orientation, slide the rear I/O-cover into the palm-rest and keyboard assembly, and snap it into place.
2. Slide the left and right Tron-light cables into their respective connectors on the system board and close the latches to secure the
cables.
3. Replace the two screws (M2.5x9) that secure the rear I/O-cover to the palm-rest and keyboard assembly.
Next steps
1. Install the
base cover.
2. Follow the procedure in After working inside your computer.
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in
Before working inside your computer.
2. Remove the base cover.
3. Remove the rear I/O-cover.
31
To Next Page
Loading...
