Alinco DR-435T - Memory Channel Data Fields

5. Basic Operation
4. While F icon is on the display, press MW key.
The VFO settings are copied to the memory
channel and a beep will sound. The memory
channel can be over-written if a previously pro-
grammed channel is selected (the memory
channels shown with a stable M icon).
5. To program the CALL channel (quick recall)
select the channel shown with CH-C on the dis-
play. Save Ch99 to store the setting used for
the Alarm operation, which will be explained
later. Use PL and PH for Program scan setting,
which will be explained in the advanced op-
erations chapter.
6. To delete a programmed channel, select it in
Memory mode, press FUNC key then press the
MW key while F icon is on. The memory is de-
leted and a beep sounds. The M icon starts flash-
ing showing that this channel is now empty.
7. To undo delete, repeat 6. However, the Undo
function becomes impossible once the channel
or the mode is changed.
[Programmable data in the memory channel]
Some features will be explained later, so please read this instruction manual thoroughly prior to
programming memories.
Memory channels including 0 - 99 and CALL can store following:
¢ Frequency
* Shift frequency
* Shift direction
* CTCSS tone both encode and decode
* Tone Squelch setting
* DCS code both encode and decode
* DCS squelch setting
* Scan skip channel
* Busy Channel Lock Out setting
* Priority monitoring frequency (PC programming required)
* Normal/Narrow FM width
* AM air-band receive (available on DR- 135T / 235T only)
NOTE: Only the frequency can be stored in PH. and PL channels to determine the edges oft the: rogram
scan range.
18