Alinco DR-435T - Parameter: Auto Power Off (APO); Parameter: Tone-Burst Frequency; Parameter: Busy Channel Lock-Out; Parameter: Theft Alarm

6. Parameters Setting Mode
Time-Out-Timer
The TOT feature is popular in repeater systems. It prohibits the users from transmitting on the
repeater after a certain period of time has elapsed. By setting this function and activating it accord-
ing to the repeaters’ requirement, the radio alerts the user by a beep 5 seconds prior to time-out.
When the time is expired, transmitting stops and the transceiver automatically returns to receiving
mode. This avoids the repeater going into its TOT mode. Until the PTT is released once and pressed
again, the transceiver will not transmit.
1.
3.
In this Menu the default display shows TOT-
OFF.
Rotate the main dial to select time-out time.
The display should change as shown. The num-
ber followed by TOT is the time-out time in
seconds.
The TOT feature is selectable up to 450 sec-
onds (7.5 minutes).
TOT Penalty
When the transmission is shut down in the TOT mode, this function prohibits another transmission
for a selected time period.
1.
During the TOT penalty period, the beep sounds
when the PTT is pressed but the radio does not
transmit.
If the PTT is continuously pressed over both
TOT and the TOT penalty period, this function
will be automatically cancelled.
Default setting is TP-OFF. Rotate the main dial
to select the penalty time, up to 15 seconds.
dT- 6é
during the seiting time of 60 seconds
during the setting time of 5 seconds
23