Alinco DR-435T - Page 49

Appendix
Command | form te
Default Parameters Description
Name Short
RESET RESET Restores the default status for all the commands.
RESPTIME RES Specifics the acknowledgement packet transmission delay.
The unit of the parameter is 100 milliscconds.
RESTART RESTART Causes the TNC function as if it is switched OFF then ON.
RETRY RE Specifies the number of transmission retrics. If packets are
not correctly accepted while connected, a connect request
is sent again after the specified number of retrics.
SENDPAC SE Specifies a character that forces a packet to be sent.
SLOTTIME SL Specifics the period of random number gencration intervals
for the PERSIST/SLOTTIME method. The unit of the pa-
rameter is 10 milliseconds.
TRACE TRAC When ON, causes the TNC to display all reecived packets
in their entirety.
TRIES TRI 0 0 Specifics the number of transmission retrics programmed
in the retry counter.
TXDELAY TX 50 50 Specifies the time delay between PTT ON and start of
transmission. The unit of the parameter is 10 milliseconds.
UNPROTO U CQ CQ Specifies call signs to send a packet in Unprotocol mode.
Call 1 is the call sign of the destination. Call2 to call9 are
call signs of stations to be digipcated through.
XFLOW x ON ON Causes the TNC to perform software flow control when
MEMO
ON, or hardware flow control when OFF.
47