ALKOTA 3182 - Troubleshooting; Safety Instructions; Specifications

3182 - OPERATION TABLE OF CONTENTS
OIL FIRED ELECTRIC DRIVEN CLEANER
01-16-04 Z08-03937
Supersedes 09-17-03 z08-03937
2
OPERATION - TABLE OF CONTENTS
SAFETY INSTRUCTIONS
Page Number
• Safety Symbols 3
• General 3
• Mechanical 4
• Electrical 4
• Fuel 4
INSTALLATION
• Location 5
• Electrical 5
• Extension Cord 5
• Venting 6
• Water Supply 6
• Barrier 6
• Water Conditions 6
• Freezing 6
• Cold weather 6
• Chemicals 6
VENTING
• Draft Diverters 6
• Venting Installation Information 7
OPERATION
•Pre Start-Up 7
•Start-Up 7
•To Clean, Apply Chemical, To Rinse 8
•Shut Down 8
(OPTIONAL) Combination Instructions 9
MAINTENANCE
Machine
• Flushing, Storage 11
• Spray Tip Maintenance 11
• Belt Tension 12
• Coil Back Pressure 12
• Schedule 10
Burner
• Fuel Pump Filter See Parts List Section
• Transformer Check See Parts List Section
• Burner Gun Remove/Replace
See Parts List Section
• Blower Fan Remove/Replace
See Parts List Section
Fuel Filter See Parts List Section
TROUBLESHOOTING
Page Number
• Machine 13, 14
• Water Heater 15
• Oil Burner See Parts List Section
• Pump See Parts List Section
• Fuel Filter See Parts List Section
SERVICE
• Pump See Parts List Section
• Fuel Filter See Parts List Section
• Trigger Gun See Parts List Section
• Unloader See Parts List Section
COMPONENT ADJUSTMENT
Burner
• Air Band Adjustment
See Parts List Section
• Buss Bar Alignment
See Parts List Section
• Electrode Ass’y Adjustment
See Parts List Section
Chemical Metering Valve
See Parts List Section
Temperature Control (If So Equipped)
See Parts List Section
Unloader Valve
See Parts List Section
PUMP OIL CHANGE
RECORD See Parts List Section
WARRANTY Inside Back Cover
SPECIFICATIONS 1