08-15-03 Z08-2830A
15. Do not start the machine unless the gun
assembly is firmly gripped by the machine
operator. Failure to do this could result in injury
from a flying hose and gun assembly.
16. Always point the gun assembly in a safe
direction and do not direct spray on the cleaner
or personnel in the area.
17. Always shut down machine before refueling.
18. Do not overfill the fuel tank. If any spillage
occurs, clean up immediately and/or neutralize
the spill before attempting to operate the
machine.
MECHANICAL SAFETY
1. All guards, shields, and covers must be replaced
after adjustments are made to prevent
accidental contact with hazardous parts.
2. Drive belts must be inspected and tightened
periodically to operate at optimum levels.
3. Inspect machine for damaged or worn
components and repair or replace to avoid
potential hazards. Do not operate the machine
if any mechanical failure is noted or suspected.
4. Always use the correct size spray tip found in
the GENERAL section of the MODEL
SPECIFICATIONS or MODEL EXPLODED
VIEW.
ELECTRICAL SAFETY
1. This machine must be electrically grounded.
Failure to have the machine grounded may
result in the operator being electrically shocked
and even death.
2. Do not plug–in or un–plug machine with wet
hands.
3. Keep power cords and connections (connectors)
out of water.
4. If an extension cord must be used to operate
this machine, it should be as short as possible.
The extension cord must be properly sized and
fitted with a grounding type plug and
receptacle.
5. All wiring and electrical connections should
comply with the National Electrical Code (NEC)
and with local codes and practices.
6. Fuses or circuit breakers should be compatible
with machine requirements. (See ELECTRICAL
section of MODEL SPECIFICATIONS for power
requirements.)
7. High voltage may be present within this machine.
Servicing should only be performed by properly
trained personnel.
FUEL SAFETY
1. Use only fuel #1 or #2 diesel. The use
of incorrect fuel may result in fire or explosion
and severe injury to the operator.
2. Do not refuel machine while it is running or hot.
Allow it to cool sufficiently to prevent ignition
of any spilled fuel. Clean up any spilled fuel
before resuming operation.
WARNING: DO NOT USE GASOLINE,
CRANKCASE DRAININGS, OR OIL
CONTAINING GASOLINE OR SOLVENTS.
AVERTISSEMENT: NE PAS UTILISER
D’ESSENCE DE PRODUITS DE VIDANGE
NI D’HUILE CONTENANT DE L’ESSENCE
OU DES SOLVANTS
WARNING: OPEN FLAME. Do not operate
this machine in an area with combustible
materials. A suitable fire extinguisher
should be available in operating area.
4
WARNING: RISK OF INJECTION OR
SEVERE INJURY. KEEP CLEAR OF
NOZZLE. DO NOT DIRECT DISCHARGE
STREAM AT PERSONS. THIS EQUIPMENT
IS TO BE USED ONLY BY TRAINED
OPERATORS.
AVERTISSEMENT:RISQUE
D’INJECTION ET DE BLESSURES
GRAVES. SE TENIR À L’ÉCART DU JET. NE
PAS DIRIGER LE JET DE SOTIE VERS
D’AUTRES PERSONNES CONFIER
L’UTILISATION LE JET DE SOTIE VERS
D’AUTRES PERSONNES. CONFIER
L’UTILISATION DE CE MATÉRIEL À UN
ECN-02981Supersedes 09-00 Z08-02831
To Next Page
Loading...
