11. FLOAT TANK: Check the float tank to assure
it is full and the float valve shuts off securely.
12. Check the position of the ball valve (if so
equipped) on outlet line of the float tank
assuring that it is in the open position.
13. Turn the switch to the burner position.
CAUTION: Do not run the machine with the
burner switch in the on position when the fuel
tank is empty. This will cause damage to the
fuel pump and void warranty.
14. Select temperature (if so equipped).
15. With the gun assembly in hand (on trigger gun
models hold the trigger gun valve in open
position) and with a good flow of water turn
switch to the pump position.
CAUTION: A good flow of water must be flowing
from the end of a gun within 30 seconds, before
proceeding. Lack of water can cause water
pump damage.
CAUTION: DO NOT RUN PUMP WITHOUT
WATER, AS THIS WILL CAUSE DAMAGE TO
THE PUMP AND VOID WARRANTY.
CAUTION: On a machine equipped with a
trigger gun valve, if the trigger gun valve
remains in the closed position for more than 5
minutes, water pump damage may occur.
14. Turn the switch to the pump position.
15. Do not start the burner unless a full flow of
water is coming from the steam trap. Air leaks
or insufficient water to the machine means less
than full flow of water through the coil. This
could cause hose failure and burns to the
operator.
16. TO CLEAN:
A. Start on the lower portion of the area to be
cleaned and work up using long, even,
overlapping strokes.
B. Dirt is generally removed easily if grease
and/or oil is not present. However if grease
and/or oil are present, hot water and
chemical will accelerate in the cleaning
process.
17. TO APPLY CHEMICAL:
CHEMICAL: Use factory recommended
chemicals for best cleaning action and for
extended pump life. Contact your dealer for
chemicals available. Follow instructions on
chemical container.
Mix chemicals per label instructions. Use
necessary safety precautions.
A. Insert chemical screen into chemical
container
B. Adjust metering valve (if so equipped).
C. If the gun assembly is equipped with
variable or multiple nozzle assembly,
adjust as desire.
TO RINSE:
A. Close chemical metering valve (if so
equipped). NOTE: It is advisable to dip the
chemical screen in a container of clean
water and open the valve 1 minute to clean
the valve of any remaining residue.
B. If the gun assembly is equipped with
variable or multiple nozzle assembly, open
and close to clean nozzle of any remaining
residue.
C. Start from the top, working downward
using long, overlapping strokes
SHUT-DOWN
1. Turn the switch from the burner position to
the pump position.
2. After cool, clear water is coming from the end
of the wand, turn pump switch to the off
position.
3. Turn off the water supply.
4. Disconnect from electrical supply.
5. If freezing conditions may exist, refer to
STORAGE in MACHINE MAINTENANCE.
6. Replace stack cover (if so equipped).
08-15-03 Z08-02830E
8ECN-02981Supersedes 09-00 Z08-02835
To Next Page
Loading...
