11-21-03 Z08-00481A
15.Always point the gun assembly in a safe
direction and do not direct spray on the cleaner
or personnel in the area.
MECHANICAL SAFETY
1. All guards, shields, and covers must be replaced
after adjustments are made to prevent
accidental contact with hazardous parts.
2. Drive belts must be inspected and tightened
periodically to operate at optimum levels.
3. Inspect machine for damaged or worn
components and repair or replace to avoid
potential hazards. Do not operate the machine
if any mechanical failure is noted or suspected.
4. Always use the correct size spray tip found in
the GENERAL section of the MODEL
SPECIFICATIONS or MODEL EXPLODED
VIEW.
5. DO NOT start the machine until you have
observed all safety and operating instructions
found in the engine manual..
ELECTRICAL SAFETY
1. This machine must be electrically grounded.
Failure to have the machine grounded may
result in the operator being electrically shocked
and even death.
2. Do not plug–in or un–plug machine with wet
hands.
3. Keep power cords and connections (connectors)
out of water.
4. If an extension cord must be used to operate
this machine, it should be as short as possible.
The extension cord must be properly sized and
fitted with a grounding type plug and
receptacle.
5. All wiring and electrical connections should
comply with the National Electrical Code (NEC)
and with local codes and practices.
6. Fuses or circuit breakers should be compatible
with machine requirements. (See ELECTRICAL
section of MODEL SPECIFICATIONS for power
requirements.)
7. High voltage may be present within this machine.
Servicing should only be performed by properly
trained personnel.
SAVE THESE SAFETY
INSTRUCTIONS
INSTALLATION
1. BARRIER: We recommend a barrier be installed
between the machine and wash area to prevent
moisture from coming in direct contact with
electrical controls and engine. This will increase
the machine’s life and lessen electrical
problems.
2. WATER SUPPLY: This machine must have a
water supply meeting or exceeding the
maximum discharge volume specified in the
machine specifications, and a minimum water
inlet pressure of 40PSI / 12.1KGM.
3. WATER CONDITIONS: Local water conditions
affect the coil adversely more than any other
element. In areas where troublesome conditions
may exist with like equipment (such as water
heaters), we recommend the use of a water
softener.
4. FREEZING: This machine must be protected
from freezing according to STORAGE section
of MACHINE MAINTENANCE.
5. CHEMICALS: Mix chemicals per the chemical
manufacturers printed directions. Follow all
mixing, handling, application, and disposal
instructions. Wear gloves, boots, goggles, and
protective clothing appropriate for the chemical
being used
4
WARNING: RISK OF INJECTION OR
SEVERE INJURY. KEEP CLEAR OF
NOZZLE. DO NOT DIRECT DISCHARGE
STREAM AT PERSONS. THIS EQUIPMENT
IS TO BE USED ONLY BY TRAINED
OPERATORS.
AVERTISSEMENT:RISQUE
D’INJECTION ET DE BLESSURES GRAVES.
SE TENIR À L’ÉCART DU JET. NE PAS
DIRIGER LE JET DE SOTIE VERS D’AUTRES
PERSONNES CONFIER L’UTILISATION LE
JET DE SOTIE VERS D’AUTRES
PERSONNES. CONFIER L’UTILISATION DE
CE MATÉRIEL À UN OPÉRATEUR QUALIFIÉ.
ECN-03022Supersedes 02-12-01 Z08-00481A
To Next Page
Loading...
