With the supplied tamper proof Torx wrench, remove bolts and washers on the left and
right side of the “YOUR SPEED” sign. Do not loosen the center bolt. Rotate the “YOUR
SPEED” up. Return the washers and the bolts to the holes and tighten with the Torx
wrench to secure the sign. Reverse steps to rotate the sign back down for storage.
The provided thumb screws can also be used to mount the sign. The Torx screws are
tamper proof, but the thumb screws are not.
NOTE: During operation in the Speed Limit Sign mode, replace the “YOUR SPEED” sign
with a “SPEED LIMIT” sign to prevent confusion. More information on this mode is
provided in the operation section.
NOTE: During operation in “stealth mode” with data collection on but with the display off
the “your speed” sign can be removed. Note how the hardware is assembled on the center
screw for so you can reassemble it correctly.
To Next Page