SpeedSentry Radar Speed Display - 6
Speedsentry Factory Recertified Quick Start
Remove the unit, batteries, and charger kit from the boxes.
Place 1/4" fender washers onto 1/4-20 phillips screws, and insert the screws into handle.
Tighten with a Philips screwdriver.
Install Mounting Hardware to Aluminum Pole
Use the U-bolts to secure it to an aluminum pole. Make sure the projecting screws on the
mounting plate face traffic.
Install Mounting Hardware to U-Channel or Square Pole
Use the carriage bolts, washers and nuts to secure it to a U-channel or square pole with
the nuts on the traffic side of the plate. Make sure the projecting bolts on the mounting
plate face traffic.
To Next Page
Loading...