What to do if lever switch (REX) not responding to lever rotation on Allegion SCHLAGE XE360 Door locks?
If the lever switch (REX) is not responding to lever rotation on your Allegion Door locks, verify the REX functionality in FDR mode with a 90-degree rotation. Remove the interior assembly and reconnect the REX wiring harnesses.
What to do if lever switch (REX) not responding to lever release on Allegion SCHLAGE XE360 Door locks?
If the lever switch (REX) is not responding to lever release on your Allegion Door locks, verify the REX functionality in FDR mode when you release the lever. Remove the interior assembly and reconnect the exterior REX wiring harnesses.
What to do if exit device switch (REX) not responding to push pad press on Allegion SCHLAGE XE360 Door locks?
If the exit device switch (REX) is not responding when the push pad is pressed on your Allegion Door locks, verify the REX functionality in FDR mode by fully pushing in the exit device push pad. Remove the interior assembly and reconnect the REX wiring harnesses. Check the exit device push pad switch and the wiring harness connections in the exit device.
What to do if mechanical override key cylinder does not permit entry from the exterior side of the Allegion Door locks?
If the mechanical override key cylinder does not permit entry from the exterior side of the door with your Allegion Door locks, remove the device from the door and verify that the spindles are installed. Ensure that with the key inserted and rotated, rotating the exterior lever gives the access control system the latch or chassis.
General| Type | Electronic Deadbolt |
|---|---|
| Power Supply | 4 AA Batteries |
| User Codes | Up to 19 User Codes |
| Keyway | Schlage C Keyway |
| Access Method | Keypad |
| Finish | Bright Brass, Satin Nickel, Aged Bronze |
| Grade | ANSI Grade 2 |
| Backset | 2-3/8" or 2-3/4" |
| Strike | Reinforced |
| Handing | Reversible |
| Compliance | ANSI A156.36 |
| Warranty | Limited lifetime mechanical |
| Keypad | Backlit numeric keypad |
To Next Page
