What to do if lever switch (REX) not responding to lever rotation on Allegion SCHLAGE XE360 Door locks?
If the lever switch (REX) is not responding to lever rotation on your Allegion Door locks, verify the REX functionality in FDR mode with a 90-degree rotation. Remove the interior assembly and reconnect the REX wiring harnesses.
What to do if lever switch (REX) not responding to lever release on Allegion SCHLAGE XE360 Door locks?
If the lever switch (REX) is not responding to lever release on your Allegion Door locks, verify the REX functionality in FDR mode when you release the lever. Remove the interior assembly and reconnect the exterior REX wiring harnesses.
What to do if exit device switch (REX) not responding to push pad press on Allegion SCHLAGE XE360 Door locks?
If the exit device switch (REX) is not responding when the push pad is pressed on your Allegion Door locks, verify the REX functionality in FDR mode by fully pushing in the exit device push pad. Remove the interior assembly and reconnect the REX wiring harnesses. Check the exit device push pad switch and the wiring harness connections in the exit device.
What to do if mechanical override key cylinder does not permit entry from the exterior side of the Allegion Door locks?
General| Type | Electronic Deadbolt |
|---|---|
| Power Supply | 4 AA Batteries |
| User Codes | Up to 19 User Codes |
| Keyway | Schlage C Keyway |
| Access Method | Keypad |
| Finish | Bright Brass, Satin Nickel, Aged Bronze |
| Grade | ANSI Grade 2 |
| Backset | 2-3/8" or 2-3/4" |
| Strike | Reinforced |
| Handing | Reversible |
| Compliance | ANSI A156.36 |
| Warranty | Limited lifetime mechanical |
| Keypad | Backlit numeric keypad |
Phone number and website for customer support.
Explains the meaning of WARNING, CAUTION, and NOTICE symbols.
Details FCC compliance, interference statements, and module listings.
Covers Industry Canada regulations, RF exposure, and NFC support.
Lists supported credential types/formats and product certifications.
Illustrates different XE360 lock models and their components.
How to use credentials, placement, and security recommendations.
Explains the four adaptable locking functions of the XE360 Series.
Instructions for battery replacement for different XE360 models.
Covers manual key unlocking and adding locks to the access control system.
Guidelines for yearly maintenance to optimize lock security and condition.
Describes normal, multi-family, and commercial construction modes.
Instructions for updating the lock's firmware using the MAPP.
Procedure for replacing the FleX Module in exit device configurations.
Steps for replacing the FleX Module in tubular and mortise lock types.
Detailed steps for rekeying tubular and mortise lock cylinders.
Instructions for rekeying exit device cylinders.
Explanation of visual and audible indicators for lock status.
Process for resetting the lock to factory default settings.
Diagnostic steps to verify the functionality of the Door Position Switch.
Diagnostic steps to confirm the Request for Exit functionality.
Guide to resolving common problems with the XE360 lock.
To Next Page
