Qu Mixer User Guide 35 AP9372 iss.4
6.15 Working with the sends on faders:
Select a Mix - Press a Mix key. The master strip presents the
mix fader and controls. The channel faders move to present
the sends to that mix.
Adjust Send levels – For Mix and FX sends. Move the
channel faders. These become the sends to the selected mix.
Adjust Send pans - While a stereo Mix is selected, press a
channel Sel key and use the Pan control to pan its send in
the mix.
Assign sends to the mix – Hold the Assign key to view the
current channel assignments (routing) to the mix. The Sel
keys light when the channel is assigned to the mix. To toggle
individual assignments on or off, press channel Sel keys
while holding Assign.
To toggle all assignments on or off - Hold the Assign key
and press the master strip Sel key.
Set sends Pre or Post fader – For Mix and FX sends. Hold
the Pre Fade key to view the current channel pre/post fade
settings for the mix. The Sel keys light when set to Pre-fade.
To toggle individual sends pre or post, press the channel Sel
keys while holding Pre Fade. It is typical to use Pre-fade for
monitor sends and Post-fade for effects sends.
To toggle all sources Pre or Post Fade - Hold the Pre Fade
key and press the master strip Sel key.
Group mixes – Selecting a Grp mix lets you assign channels
and FX returns to the group. The LR mix channel faders and
pan positions remain active. Groups are not available on the
Qu-16.
Press the Mix key again or press LR to return to the main
mix, or press another Mix key to adjust a different mix.
Note Always remember to return to the main LR mix once you
have finished adjusting monitor or effects levels.
Sends on faders
Pre/Post
Assign
Toggle individual sources Toggle all sources Hold and then press Sel
Qu-16
Qu-24 and 32
To Next Page
Loading...
Need help?
General
