Allen & Heath 21 XONE:3D User Guide
OUTIN
FX2 SEND
WARNING: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE
REPLACE FUSE WITH SAM E TYPE AND RATING.
UN DES MEMES CARACTERISTIQUES.
ATTENTION: REMPLACER LE FUSIBLE AVEC
DO NOT EXPOSE APPARATUS TO RAIN OR MOI STURE.
TO REDUCE THE RI SK OF FI RE OR ELECTRIC SH OCK
WARNING: THIS APPARATUS MUST BE EARTHED.
CAUTION
100 - 240V~
47-63Hz ~ 30W MAX
MADE IN THE UK BY ALLEN & HEATH LIMI TED
FUSE
T500mAL 250V 20mm
MIX OUT
LEFT RI GHT
I
0
ON
OFF
SERIAL No:
AC MAINS IN ~
TO PC
USB
GAM E / M I D I
FOOT
SWI TCH
FX RETURNS
MIDI
LI NE
LRPHONO
LR
LI NE
LRPHONO
LR LINE
LRPHONO
LR LI NE
LRLI NE
LR FX2
LRFX1
LR
INPUT 1INPUT 2INPUT 3INPUT 4
CH1
SOUNDCARD OUTPUTS
R
L
FX1 SEND
R
L
MONITOR
R
L
SPDI F
OUT
IN
L
CH2
R
CH3
L
CH4
R
CH5
L
CH6
R
IN OUT
DIGITAL AUDIO
OPT I CAL
A
B
REAR CONNECTORS
6 9 8 7
10
FX1-2 Send Output
RCA phono. Depending on the
application of the FX mix, these stereo
line level outputs can be used to feed
samplers and other effects units, an
additional monitor, zone or recorder.
8
Soundcard Outputs
RCA phono.
Outputs from the internal soundcard.
These are always available irrespective of
the source selection on the stereo
channels. These outputs could be fed to
an additional mixer or processor before
being brought back into the mix.
Depending on the soundcard operating
mode, signals are available on sockets 1-6
or 1-4.
9
SPDIF DIGITAL INPUTS
AND OUTPUTS
SPDIF is a popular digital audio interfacing
standard for connecting two channel
(stereo) audio using a single coax (RCA
phono socket) or optical fibre (Toslink
socket) cable.
For reliable connection use a 75 ohm coax
cable intended for this function. Avoid
the use of cheap audio cables. Use
purpose made optical fibre cables for
connection using the Toslink port. Make
sure the blanking plugs provided are fitted
to any unused Toslink sockets.
The SPDIF inputs and outputs are available
only when your computer is connected via
the USB port. The computer provides the
clocks needed for the soundcard to
function.
Sample rates of 44.1 and 48kHz are
supported with the ability to interface
with any digital source up to 192kHz.
Use the Xone:3D Configuration Utility
software to select which signals are
routed to the SPDIF connectors.
Mix Output
Balanced XLR. This is the main
output that feeds the house PA
system. Plug into the house
processor/amplifier system using
balanced cables. Use balanced
cables and equipment.
6
Monitor Output
RCA phono. Provides a line level
stereo feed to the DJ local monitor
amplifier system. It is not affected
by the master fader or cue system.
Can also be used as an alternative
zone or record output.
7
10
To Next Page
Loading...
Need help?
General
