Allen & Heath 42 XONE:3D User Guide
USER OPTIONS
Internal Link Options
The Xone:3D offers several internal option settings:
• FX1 and FX2 Return Routing— The FX1 and FX2 Returns are set, by
default, to route to the main LR Mix. Link options allow the return to be
routed through either Filter 1 or Filter 2.
• Disabling / Enabling RIAA Preamps—All channels are fitted with
RIAA preamplifiers. Link options allow the RIAA preamplifier stage to be
enabled or disabled. When disabled, the Phono input becomes a Line in-
put.
• FX2 Pre / Post Fade Assignment—The FX2 channel send is set, by
default, to pre-fader. Link options allow the channel FX2 send to become
post-fader.
CAUTION : Refer the above link options to an Allen and Heath approved
service centre only. To reduce the risk of electric shock do not perform any
servicing other than that described in the operating instructions unless you are
qualified to do so.
Replacing the Crossfader
Replacement crossfader Assembly: Allen & Heath Part No. 003-579. Please
contact your Allen and Heath approved service centre to undertake crossfader
replacement.
Overlay Sheets
There are two versions of template depending upon the serial number of the
Xone:3D console. These versions have slightly different control layout.
For Serial numbers starting X3D:
• replacement templates kit: 003-536
• Replacement Ableton templates only: AN6441
• Replacement Native templates only: AN6442
For Serial numbers starting X3D:
• replacement templates kit: 003-704
• Replacement Ableton templates only: AN6880
• Replacement Native templates only: AN6881
To Previous Page
Loading...
Need help?
General
