Start-Up
4-10
❏ 18. Check for proper operation.
or
Slowly Increase Speed
or
a.) Start the drive.
b.) Slowly increase the speed. Check for proper motor operation throughout
the speed range.
c.) Press the Stop key.
At Speed
+5.00 Hz
Stopped
+0.00 Hz
At Speed
+60.00 Hz
❏ 19. This completes the basic start-up procedure. Depending on your
application, further parameter programming may be required. Refer to
Chapter 5 for information.
Important: The parameters in the Set Up Group (page 5-8) should be
reviewed and reprogrammed as necessary for basic operation.
efesotomasyon.com - Allen Bradley,Rockwell,plc,servo,drive
To Next Page
Loading...
Need help?
General
