7–7Application Examples
Publication
17476.6 - July 1996
N7:0
1
( )
0
M0:1.17
END
] [
S:1
Move input word 10 (I:1.10) from the DCM
to output word 2 (O:1.2) of the RediP
ANEL.
MOV
MOVE
Source I:1.10
Dest O:1.2
MOV
MOVE
Source M1:1.2
Dest N7:1
] [
I:1.0
8
( )
1
O:1.10
MOV
MOVE
Source M1:1.8
Dest N7:2
MOV
MOVE
Source M1:1.9
Dest N7:3
Bit 8 of the RediPANEL input word 0
activates bit 1 of the DCM output word 2.
Upon the first processor scan, move the
baud rate setting, device address, and
device size to integer file N7.
MOV
MOVE
Source M1:1.10
Dest N7:4
MOV
MOVE
Source M1:1.0
Dest N7:0
N7:4
0
MOV
MOVE
Source 4
Dest O:1.2
Move the active device status and
general status words to integer file N7
upon each scan.
If communications is attempted and the
RediP
ANEL is not communicating, reset
the DCM.
If communications is attempted and the
DCM is not communicating, display
message 4 on the RediP
ANEL.
15
N7:4
4
N7:0
1
To Next Page
Loading...