4–27Scanner Configuration and Programming
Publication
17476.6 - July 1996
RIO Status Example
The following example illustrates an M1 status file example. It
shows a typical M1 file and the G file used to configure the scanner.
There are no inhibited devices specified in the M0 file (not shown).
Notice that:
• M1:e.8 is an image of word 1 (primary/normal logical device
address) of the G file.
• M1:e.3 is an image of word 3 (complementary logical device
address) of the G file.
• M1:e.9 is an image/copy of word 2 (primary/normal logical
device size) of the G file.
• M1:e.4 is an image/copy of word 4 (complementary logical
device size) of the G file.
• The three quarter logical rack device located in logical rack 3
(M1:e.9/13) is not active. The fault is indicated by the Enabled
Device Fault status bit, bit 0, word 0 (M1:e.0/0).
• The three quarter logical rack device located in logical rack 11
(M1:e.4/13) is not active. The fault is indicated by the Enabled
Device Fault status bit, bit 0, word 0 (M1:e.0/0).
Because the device at M1:e.8/13 is faulted, bit 13 of word 10
(M1:e.10/13) is 0. M1:e.15/1 through M1:e.15/3, which
correspond to M1:e.9/13 through M1:e.9/15 are also set to 1,
indicating a problem with the device in logical rack 3.
Because the device at M1:e.3/13 is faulted, bit 13 of word 5
(M1:e.5/13) is 0. M1:e.15/5 through M1:e.15/7, which
correspond to M1:e.4/13 through M1:e.4/15 are also set to 1,
indicating a problem with the device in logical rack 11.
0123456789101112131415
11xxxxxxxxxxxxxx
RIO Logical
Rack 0
Status Word, Word 0
RIO Logical
Rack 1
RIO Logical
Rack 2
RIO Logical
Rack 3
10xxxxxxxxxxxxxx
Baud Rate, Word 2
M1:e.0
M1 File
M1:e.2
M1:e.8
M1:e.9
M1:e.10
xxxxxxxxxxxx
M1:e.12
xxxxxxxxxxxx
M1:e.13
xxxxxxxxxxxx
M1:e.14
xxxxxxxxxxxx
M1:e.15
M1
(Status) File Primary/Normal
1 100
1
00001000100
1001111101100111
1001100001000000
000 0
000 0
000 0
111 0
1 100
1
00001000100
1001111101100111
RIO Logical Rack 3
Starting Group
0246
Primary Logical Device Address, Word 1
Primary Logical Image Size, Word 2
e = slot number of the SLC rack containing the scanner
x = not used/defined
G
File
Bit Number (decimal)
RIO Logical Rack 2
Starting Group
0246
RIO Logical Rack 1
Starting Group
0246
RIO Logical Rack 0
Starting Group
0246
Primary Device Address, Word 8
Primary Device Size, Word 9
Primary Active Device Status, Word 10
Logical Rack 0 Device Fault Status Word 12
Logical Rack 1 Device Fault Status Word 13
Logical Rack 2 Device Fault Status Word 14
Logical Rack 3 Device Fault Status Word 15
To Next Page
Loading...