M0–M1 Files and G Files B–11
Publication
17476.6 - July 1996
Editing G File Data
Data in the G file must be edited according to your application and
the requirements of the specialty I/O module. You edit the data
offline under the I/O configuration function only. With the decimal
and hex/bcd formats, you edit data at the word level:
• G1:1 = 234 (decimal format)
G1:1 = 00EA (hex/bcd format)
With the binary format, you edit data at the bit level:
• G1/19 = 1
Important: Word 0 of the G file is configured automatically
by the processor according to the particular
specialty I/O module. Word 0 cannot be edited.
To Next Page
Loading...