Publication 1794-6.5.12 - November 1997
How to Install Your Thermocouple/RTD/mV Input Module 2-5
Slide the terminal base unit over tight against the adapter.
Make sure the hook on the terminal base slides under the edge of the
adapter and the flexbus connector is fully retracted.
7
7
4
1
30077-M
7
7
6
2
3
4
0
9
8
1
Press down on the terminal base unit to lock the terminal base on the
DIN rail. If the terminal base does not lock into place, use a screwdriver
or similar device to open the locking tab, press down on the terminal
base until flush with the DIN rail and release the locking tab to lock the
base in place.
Gently push the flexbus connector into the side
of the adapter to complete the backplane connection.
To Next Page
Loading...
