Need help?Do you have a question about the Allen-Bradley 1794-IF4I and is the answer not in the manual?
General| Category | I/O Systems |
|---|---|
| Manufacturer | Allen-Bradley |
| Product Type | Flex I/O Analog Input Module |
| Input Channels | 4 |
| Resolution | 16 bits |
| Accuracy | ±0.1% of full scale |
| Relative Humidity | 5 to 95% (non-condensing) |
| Input Type | Analog |
| Current Input Range | 0 to 20 mA, 4 to 20 mA |
| Voltage Input Range | 0 to 10V, -10 to +10V |
| Isolation Voltage | 1500 V |
| Operating Temperature | -40°F to 140°F |
| Storage Temperature | -40°C to 85°C (-40°F to 185°F) |
| Power Supply | 24V DC |
| Module Location | Flex I/O |
Explains critical warning symbols (WARNING, ATTENTION, etc.) and their meanings for safe operation.
Explains the communication process between modules and controllers.
Describes the general process of installing an analog module.
Provides essential wiring instructions for connecting analog modules.
Explains the fundamental block transfer programming concept.
Explains how to configure module features like range and data type.
Describes the process of retrieving status and data from the module.
Explains the necessity and methods for calibrating analog modules.
Details the calibration process for analog input modules.
Provides the procedure for setting the offset for input channels.
Details the calibration process for analog output modules.
Highlights critical explosion hazard warnings for operation in hazardous locations.
To Next Page