Publication 1794-6.5.12 - November 1997
2-6 How to Install Your Thermocouple/RTD/mV Input Module
4. Repeat the above steps to install the next terminal base.
Panel/Wall Mounting
Installation on a wall or panel consists of:
• laying out the drilling points on the wall or panel
• drilling the pilot holes for the mounting screws
• mounting the adapter mounting plate
• installing the terminal base units and securing them to the wall or
panel
If you are installing your module into a terminal base unit that is already
installed, proceed to “Mounting the Thermocouple/RTD/mV Module on
the Terminal Base” on page 2-8.
Use the mounting kit Cat. No. 1794-NM1 for panel/wall mounting.
1.4
(35.5)
1
1794-NM1 Mounting Kit
Contents:
1 - Mounting Plate for Adapter
2 - 18 #6 self-tapping screws
(2 for the adapter, and 2
each for up to 8 modules)
2
Adapter Module
(not included)
Terminal Base Unit
(not included)
Allen-Bradley PLCs
To Next Page
Loading...
