136 Rockwell Automation Publication 2080-UM005B-EN-E - March 2015
Appendix C Quickstarts
6. Click Yes to initiate the update.
A screen showing the download progress appears.
If you see the following error message instead, check to see if the controller
is faulted or in Run mode. If so, clear the fault or switch to Program mode,
click OK and try again.
7. When the flash update is complete, you will see a status screen. Click OK
to complete the update.
After control flashing the controller, some microSD cards may not be
detected. Remove and insert the microSD card, or power cycle the
controller if this issue is encountered.
To Next Page
Loading...
