16 Rockwell Automation Publication 750-IN001P-EN-P - April 2017
Chapter 1 Read the General Precautions
Product Safety
Class 1 Light-emitting Diode
Product
ATTENTION: An incorrectly applied or installed drive can result in component
damage or a reduction in product life. Wiring or application errors such as an
under-size motor, incorrect or inadequate AC supply, a corrosive environment,
or excessive surrounding air temperatures can result in malfunction of the
system.
ATTENTION: This drive contains ESD (Electrostatic Discharge) sensitive parts
and assemblies. Static control precautions are required when you install, test,
service, or repair this assembly. Component damage can result if ESD control
procedures are not followed. If you are not familiar with static control
procedures, see Guarding Against Electrostatic Damage, publication 8000-
4.5.2, or any other applicable ESD protection handbook.
ATTENTION: If you configure an analog input for 0…20 mA operation and
drive it from a voltage source, you can cause component damage. Verify
proper configuration before you apply any input signals.
ATTENTION: Hazard of permanent eye damage exists when using optical
transmission equipment. This product emits intense light and invisible
radiation. Do not look into module ports or fiber-optic cable connectors.
To Next Page
Loading...
Need help?
General
