Motion Error Codes, faults, and attributes
Rockwell Automation Publication MOTION-RM002H-EN-P-February 2018 617
Why is there a delay when I stop and then restart a jog?
While an axis is jogging at its target speed, you stop the axis. Before the axis stops
completely, you restart the jog. The axis continues to slow down before it speeds
up.
Example
You use a Motion Axis Stop (MAS) instruction to stop a jog. While the axis is
slowing down, you use a Motion Axis Jog (MAJ) instruction to start the axis again.
The axis does not respond right away. It continues to slow down. Eventually, it
speeds back up to the target speed.
To Next Page
Loading...
