Publication 2711C-UM001I-EN-P - July 2014 121
PanelView Component DesignStation Appendix D
We strongly recommend that you validate the transferred application using the
terminal software before running the application. Non-validated applications,
when started on the terminal, display a reminder pop-up message that the
application is not validated.
PVc DesignStation can only have one instance running on the computer at any
one time.
You can download the latest version of Connected Components Workbench for
your Micro800 at the URL below.
http://ab.rockwellautomation.com/Programmable-Controllers/Connected-
Components-Workbench-Software.
Install the Software
PanelView Component DesignStation can be installed on computers running
the following:
For better performance, your computer should have at least an Intel Pentium M
1400 MHz processor, with 512MB RAM.
Ensure that you install .NET framework 3.5 before installing the software.
Your computer information can be found by right-clicking My Computer and
then selecting properties.
Follow these steps to install the software components.
1. Go to
http://ab.rockwellautomation.com/Graphic-Terminals/2711C-PanelVie
w-Component-Terminals. to download the software components.
2. Run the executable file.
System Requirements
PanelView Component
DesignStation 2.0
PanelView Component
DesignStation 3.0
Windows XP (SP3 only) Windows XP 32 bit (SP3 only)
Windows Vista Windows Vista 32 bit or 64 bit
Windows 7 Windows 7 32 bit or 64 bit
The following installation is for the PVc DesignStation 3.0.
However, the steps involved are the same for both PVc
DesignStation 2.0 and 3.0.
To Next Page
Loading...
Need help?
General
