Publication 2711C-UM001I-EN-P - July 2014 79
Upgrade Firmware Chapter 5
3. When prompted to run the Autorun, press Yes or the F1 key.
The splash screen appears and the progress bar indicates a firmware
installation is in process.
When the firmware installation is complete and successful, the progress
bar stops with the success code OK.
4. Remove the storage device and reboot the terminal.
5. Open the system information screen to see the firmware version that is
expected after the installation.
Refer to
View System Information on page 47 for instructions on how to
view the current firmware version.
Do not remove the SD card or USB flash drive until upgrade -
OK is displayed.
To Next Page
Loading...
Need help?
General
