EasyManua.ls Logo

Allen-Bradley PowerFlex 700S - Specifications; Protection Specifications; Certifications

Allen-Bradley PowerFlex 700S
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Rockwell Automation Publication 20D-TD002L-EN-P - July 2018 103
PowerFlex 700S Drives with Phase II Control
Specifications
Category Specification Frames 1…6 (690V Drive Frames 5 & 6 Only) Frames 9 & Up
Protection
200…
208V
240V 380/
400V
480V 600V
(Frames
1…4)
600V/
690V
(Frames
5&6)
380/400V 480V 500V 600V 690V
AC Input Overvoltage Trip (Six
Pulse, Three-Phase):
300VAC 300VAC 600VAC 600VAC 863VAC 863VAC 675V AC 675V AC 675V AC 889V AC 889VAC
Bus Overvoltage Trip:
405V DC 405V DC 810V DC 810V DC 1164V DC 1164V DC 911V DC 911V DC 911V DC 1200V DC 1200V DC
Bus Undervoltage Trip:
Adjustable Adjustable
Nominal Bus Voltage:
281V DC 324V DC 540V DC 648V DC 810V DC 931V DC 540V DC 648V DC 645V DC 810V DC 931V DC
Heat Sink Thermistor: Monitored by microprocessor overtemp trip Monitored by microprocessor overtemp trip
Drive Overcurrent Trip
Software Current Limit:
Hardware Current Limit:
Instantaneous Current
Limit:
Calculated value, 105% of motor rated to 200% of drive rated
105% of 3 sec. rating (158%…210%)
143% of 3 sec rating (215%…287%)
Calculated value, 105% of motor rated to 200% of drive rated
360% of rated Heavy Duty current (typical)
Line Transients: Up to 6000 volts peak per IEEE C62.41-1991 Up to 6000 volts peak per IEEE C62.41-1991
Control Logic Noise Immunity: Showering arc transients up to 1500V peak Showering arc transients up to 1500V peak
Power Ride-Thru: 15 milliseconds at full load 15 milliseconds at full load
Logic Control Ride-Thru 0.25 seconds, drive not running 0.25 seconds, drive not running
Ground Fault Trip: Phase-to-ground on drive output Phase-to-ground on drive output
Short Circuit Trip: Phase-to-phase on drive output Phase-to-phase on drive output
Certifications ATEX EC-Type-Examination Certificate TÜV 05 ATEX 7202 for directive 2014/34/
EU.
See Appendix E in the PowerFlex 700S Drives with Phase II Control
Programming Manual, publication 20D-PM001, for more information.
EC-Type-Examination Certificate TÜV 05 ATEX 7202 for directive 2014/34/
EU.
See Appendix E in the PowerFlex 700S Drives with Phase II Control
Programming Manual, publication 20D-PM001, for more information.
C-Tick (Does not include 600V AC Input frames 1…4 drives)
Australian Communications and Media Authority
In conformity with the following:
Radiocommunications Act: 1992
Radiocommunications Standard: 2008
Radiocommunications Labeling Notice: 2008
Standards applied:
EN 61800-3
Australian Communications and Media Authority
In conformity with the following:
Radiocommunications Act: 1992
Radiocommunications Standard: 2008
Radiocommunications Labeling Notice: 2008
Standards applied:
EN 61800-3
c-UL-us Listed to UL508C and C22.2 No. 14 Listed to UL508C and C22.2 No. 14
CE In conformity with the following European Directives:
EMC Directive (2014/30/EU)
Low Voltage Directive (2014/35/EU)
Standards Applied:
EN 61800-3
EN 50178
In conformity with the following European Directives:
EMC Directive (2014/30/EU)
Low Voltage Directive (2014/35/EU)
Standards Applied:
EN 61800-3
EN 50178
TÜV TÜV Rheinland - Certification applies to 20D-P2-DG01 Safety Option
Module when installed in a frame 1…6, 208/240V and 400/480V, and
frame 5 and 6, 600/690V drives. Standards applied:
EN 61800-5-2 EN 60204-1
EN ISO 13849-1 EN 62061
IEC 61508 Part 1-7 EN 61800-3
IEC 61800-5-1
TÜV Rheinland - Certification applies to 20D-P2-DG01 Safety Option
Module when installed in a frame 9…14, 400/480V and 600/690V drives.
Standards applied:
EN 61800-5-2 EN 60204-1
EN ISO 13849-1 EN 62061
EN 61800-3 IEC 61800-5-1
IEC 61508 Part 1-7
Designed to Meet Applicable Requirements IEC 61800-2 Adjustable speed electrical power drive systems - Part 2:
General requirements
IEC 61800-5-1 Adjustable speed electrical power drive systems - Safety
requirements
NFPA 70 – US National Electric Code
NEMA 250 – Enclosures for Electrical Equipment
IEC 61800-2 Adjustable speed electrical power drive systems - Part 2:
General requirements
IEC 61800-5-1 Adjustable speed electrical power drive systems - Safety
requirements
NFPA 70 – US National Electric Code
NEMA 250 – Enclosures for Electrical Equipment

Other manuals for Allen-Bradley PowerFlex 700S

Related product manuals