Allen-Bradley PowerFlex 753 - Page 14

14 Rockwell Automation Publication 750-QS001A-EN-P - March 2015
Step 3: Power Up, Configure the Drive, and Spin the Motor Shaft
• Parameter 29 [Mtr NP Pwr Units]
For parameter 29, choose the unit of measurement is based on the actual nameplate.
If the nameplate is in HP (default unit), continue to parameter 30 [Motor NP Power].
If your nameplate value is in kW, change the default power units from HP to kW.
a. Press the soft key.
b. Use the soft key to scroll to kW.
c. Press the soft key.
• Parameter 30 [Motor NP Power]
• Parameter 31 [Motor Poles]
EDIT
▼
ENTER
Stopped
0.000 Hz
AUTO
Port 00 Dev Param 29
Mtr NP Pwr Units
HP 0
ESC EDIT
F
PAR#
Motor NP Power Units Screen Power Units Selection Screen
E S C ENTER
Stopped
0.000 Hz
AUTO
F
▲▼

Edit Mtr NP Pwr Units
HP 0
0 << 1
Power Units Selection Screen
E S C ENTER
Stopped
0.000 Hz
AUTO
F
▲▼

Edit Mtr NP Pwr Units
kW 1
0 << 1
Stopped
0.000 Hz
AUTO
Port 00 Dev Param 29
Mtr NP Pwr Units
kW 1
ESC EDIT
F
PAR#
Motor NP Power Units Screen