ASSEMBLY INSTRUCTIONS
1. Install mounting plate (A) to outlet box (not included).
Use only the screws (not included) provided with the
outlet box.
2.
Place decorative ring (B) over canopy on motor
assembly (D).
3.
Set dip switches on the remote control transmitter (J)
and remote control receiver (C) to the same setting.
This must be done so the units will communicate prop-
erly. If you have other fans you can set them to be
controlled by one transmitter by setting both receivers
the same as transmitter. If you have more than one fan
with a remote control, you can set the dip switches to
different positions to have separate control.
7
/
0
/
G
/
G
-8
cover
To Next Page
Loading...
